There is no excerpt because this is a protected post.
Category: Cisco Meraki
Cisco Meraki: How to set a wireless network to 2.4Ghz only?
In some challenging wireless environments, specifically those where you do not have 100% coverage, and especially those with a lot of concrete, leaded glass and other RF challenges – 5Ghz can be problematic. Some devices just love to hold on to 5Ghz connections even if the 2.4Ghz signal is better. On your Meraki dashboard, it … Continue reading Cisco Meraki: How to set a wireless network to 2.4Ghz only?
Tricks: Introducing Cisco RF Planning Tool
Here is a useful planning tool in Wireless Network provisioning for Cisco Meraki AP or the Mobility Express models. This is an online tool called Cisco RF Wi-Fi Planner Tool. Check out https://rftool.cisco.com You can use this by logging in to your Cisco Account. You can put into account external factors in designing your wireless network … Continue reading Tricks: Introducing Cisco RF Planning Tool
Meraki Wifi Best Practice for multiple APs: Bridge Mode
Bridge Mode In bridge mode, the Meraki APs act as bridges, allowing wireless clients to obtain their IP addresses from an upstream DHCP server. Bridge mode should be enabled when any of the following is true: Wired and wireless clients in the network need to reach each other (e.g., a wireless laptop needs to discover … Continue reading Meraki Wifi Best Practice for multiple APs: Bridge Mode
Meraki Wifi Best Practice for single AP: NAT Mode with Meraki DHCP
Below is the recommended setup for sites with single AP. There is a known issue with this setup for sites having multiple APs, particularly with user experience as one user moves from one AP to another. There is totally no handover from one AP to another as the user devices is NAT'd per AP, so … Continue reading Meraki Wifi Best Practice for single AP: NAT Mode with Meraki DHCP
Issue: Android users cannot connect to Wireless on Cisco Meraki APs
This article is to be used as a short reference guide on how to manually set up a WPA2-Enterprise with RADIUS Authentication (IEEE 802.1X) wireless profile on Android devices. This profile will allow the client devices to connect to the SSIDs configured with WPA2-Enterprise with 802.1X authentication as the association requirement. 1. At the home page, navigate … Continue reading Issue: Android users cannot connect to Wireless on Cisco Meraki APs